Or, if we'll return to detail downscaling by 1.77, this will be written just as 100/177 (instead of 1/1.77). Therefore, you have to multiply both numbers by 10s to get both integers. "The little complexity is that during the Scale command you can't do arithmetic actions with noninteger numbers. Type Scale command, select the desired object, specify the base point, and when the computer prompts for scale factor, type 18765/2540. Let’s say, you have a measured size of one of your objects equal to 187.65 millimeters and you need to scale it down to inches. Grrr …But there is an old, good, but forgotten trick. "You search for calculators, open AutoCAD internal calculator, write the number down on paper to type it in your commands. Or another case, you have to downscale details on your drawing, let's say, in 1.77 times. "At work there are many metric drawings or site measurements in metric units that should be put on drawings with imperial units. Vladislav Bronin shares his method of scaling objects without calculating a scale factor. Burst Command as WYSIWYG Block Exploder.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |